So you can drag that red line across and see historical readings on the graph?I bought big bags of the 2 part, did a res change yesterday. Added predissolved part A, filled to the water line and added predissolved part B, pH comes out to 5.7, added potassium silicate and the pH went up to 6.0, then trended down to 5.8 overnight.
This is what my bags say for measuring:
View attachment 20355
View attachment 20354
So you can drag that red line across and see historical readings on the graph?
Did you end up using the recommended dosage? If so which one?Added predissolved part A, filled to the water line and added predissolved part B,
Yes, I’m just following the bag. 1.5a/2.5b per gallonDid you end up using the recommended dosage? If so which one?
My first mix with the stuff was at 2g A / 2.5g B because I was moving into flower. The EC/PPM was a little high for my liking in RO, so I never made it to the full 2.5a/2.5b
I think it'll probably bring out the best in you. Just like all the other stuff you destroy!I'm flying by the seat of my pants!
Seems like pH landed and trended lower for me did you see anything there?Megacrop all powder v3? 1 part deficiency progression
View attachment 22276 View attachment 22277 View attachment 22278 View attachment 22279 View attachment 22280 View attachment 22281
Seems like pH landed and trended lower for me did you see anything there?
Yeah definitly disolving more difficult. I will check my veg res now as access is difficult but I just added ro and pH up last night. Nevere added pH up in veg before unless I f'd up.
Yeah in theory it works that way. I have a combo pen that can read rootzone pH and res pH I trust that more than runoff, alternatively a slurry for the soil. Since I run a f/d I havent been too keen on sticking the glass probe into the clay pebbles so I haven't.Yeah pH trends down pretty hard, I've only had to dose pH up. I've been checking the leachate pH to make sure it's not too low, for example if your res is set at 5.8 but the leachate is coming out at 5.0, that's what pH the roots are experiencing and you should adjust the initial up more. At least I think that's how it works. https://www.cropking.com/blog/understanding-hydroponic-leachate
Yeah in theory it works that way. I have a combo pen that can read rootzone pH and res pH I trust that more than runoff, alternatively a slurry for the soil. Since I run a f/d I havent been too keen on sticking the glass probe into the clay pebbles so I haven't.
I bought big bags of the 2 part, did a res change yesterday. Added predissolved part A, filled to the water line and added predissolved part B, pH comes out to 5.7, added potassium silicate and the pH went up to 6.0, then trended down to 5.8 overnight.
This is what my bags say for measuring:
View attachment 20355
View attachment 20354
I'm guessing this measurement is per gallon correct?
I ask because I went to use my MC V2 and it was a brick from improper storage. So I ordered the two part and it just arrived. I mixed it up yesterday, (I use 5 gallon batches) and the pH was 5.8. How much potassium silicate did you use to bring it up to 6.0? It'll help me narrow down the trial and error process of bringing mine up. Thanks in advance